Stepped off the airplane circuit for a bit while I continue to rig my Revell 1/96 constitution.
If you’ve built one of these Revell wonders in the past you will remember that the shrouds and ratlines come to you in the kit prepackaged. You cut them on a pattern and tie them to a set of plastic deadeyes that resemble the real thing as shown here in a previously built Revell Cutty Sark.
The plastic stuff wasn’t going to be good enough for the Constitution.
I’m rigging the main mast shrouds. I previously installed the lower set of deadeyes when I assembled the hull.
Unlike model airplane building this involves hours of repeated tasks. There are 16 individual pairs of deadeyes and each one rigged to a shroud requires two siezings (wrapping thread around the strand to hold them together) and running the thread through the deadeyes to pull down the shroud. Over and over again!
But the results can be worth it and shown in the foremast shrouds completed here.
Half way done with the mainmast, then I get to rattle them all down, rig a few stays, and onto the Mizzen Mast!