Eduard Brassin for Fw-190

I am slowly progressing on the Eduard Fw-190.  One of greatest values of resin parts is the detail you can achieve without scratch modeling.  One of the greatest hassles is that everything needs to go together and sometimes the resin doesn’t quite fit.

This is the case with the Eduard Brassin set for the Fw-190.  The bulkhead under the fuselage guns is not wide enough requiring I do SOME MODELING!?  I don’t know if the issues is that I am using the Fw-190A-5 set for an Fw-190A6 but I am aware that the A-5 and A-6 had the same fuselage (the wing was redesigned for the A6).  However, I wonder how the Eduard Fw-190A5 kit stacks next to the Fw-190A6.

Anyway, some modeling was needed to extend the width of the bulkhead so that it will fit.  I confirmed before I began that the wings attach almost perfectly to the fuselage which gives me sense the kit is the right size and the resin is wrong.

BTW Eduard provides a very ingenious method to ensure the fuselage is spread correctly for the wings by using the front of the cockpit insert as a spreader.  Good job Eduard!

Previously with my DML/Dragon Fw-190s I would have to glue the upper wings to the fuselage first and then use gluing the upper to lower as a way to spread the fuselage and avoid a wing root gap.  Not the case this time!

Despite all this, the Brassin parts are very nice!

Here are some in-process shots.  The white styrene shows the difference in the width between the kit part and the brassin part.

 

 

Advertisements